Part number: MH-EYES3 (M25H-EYES3) · Conductors: 3, independently drivable · Available in: 25 Series · Print: ~3 hours (reflected in price)
Read the Full Story & Testing NotesProduct Discussion on Discord (members)
The Eyes profile with three separate conductive zones - three stimulation points on one head, each on its own connection.
25 Series only. Heads are series-locked: you get the head built for that shaft diameter, and it fits that series only. A 25 Series head will not go on a 32 Series shaft.
Some ways to run it
There are a lot of ways to wire three zones. A few favorites:
A channel just across the eyes hits the prostate. Then run a second channel from the back of the head to the peri pad.
The way I like best is one eye out to a ring. Take a tip ring like the Pinnacle and wire one eye to each side of it - corona side and frenulum side. Eye to eye is nice, but eye to ring is better: with both poles on the head the current stays up there, and once you send a channel out to a ring the current has to cross the prostate rather than run beside it.
Use the third zone for a PeriPla™ pad or the probe base, and a Switch 1 multiplies the combinations mid-session - flipping to the A+B centre position changes the surface area of the head, which drives deeper prostate sensation and more intensity in the ring.
Cables - read this before you order
Clearance in the head is tight: the cable head has to be 8mm or under. If you already have 4mm cables, measure them first. Nothing is worse than a new head and the wires do not fit.
Running multiple zones means a cable per channel. A 90/straight covers a channel from the head out to a ring - straight end in the head, 90 on the ring. Add a straight/straight if you want to run two zones of the head against each other, or to feed a Switch 1, whose input has to be straight. 2.5mm ends if you are on a Coyote, 3.5mm for most other boxes.
Details
Three M2×40 screw holes - one per port; each installed screw cuts that connection's resistance about 30% and strengthens the neck. Locks into its shaft with a 90° PlaLok™ turn - check the lock indicator before use.
Care: consumable part - inspect before every use, disassemble to clean with warm water and dish soap, and follow the Care and Safety Instructions.
Goes well with
The Pinnacle - Frenulum/Corona Tip Ring
The One - Round Shaft Ring
The Clarifier - Bipolar Shaft Ring
Switch 1
Really Good E-Stim Cable
Build your own 4mm cables
