Read the Full Story & Testing NotesProduct Discussion on Discord (members)
Part number: MH-CRANE3 (M25H-CRANE3) · Conductors: 3, independently drivable · Size: 103mm high, 60mm wide · Available in: 25 Series · Print: ~5.5 hours (reflected in price)
This is not a small head. At 103mm high and 60mm wide, it is big - Eurasian crane big. Total conductive area is 13,218mm² against 5,079mm² for the standard 25 Series egg head: about 2.6 times the surface.
25 Series only. Heads are series-locked: you get the head built for that shaft diameter, and it fits that series only. A 25 Series head will not go on a 32 Series shaft.
A few notes on this one
1. That enormous surface area means each of the 3 segments hits hard. This head is the strongest feeling of all the heads to date.
2. It is big. My experience: after insertion without warming up, it felt uncomfortably big for the first 2-3 minutes. After that initial discomfort, it just felt big.
3. The experience is unique and powerful. Compared to something like the E-Stim Systems triple (medium), which is itself a large probe, it felt much stronger, bigger, and more comfortable.
Some ways to run it
One of the best ways to use the triple conductor is with a tip ring like the Pinnacle. Corona channel to the bottom segment, frenulum channel to the tip. If you have another channel available, run the centre of the head to the perineum pad, or to the base of the probe.
That sends the current out across the prostate rather than keeping it up in the head, which is where the difference is felt. A Switch 1 pairs well here too - it lets you move between segments mid-session without unplugging anything.
Cables - read this before you order
Clearance in the head is tight: the cable head has to be 8mm or under. If you already have 4mm cables, measure them first. Nothing is worse than a new head and the wires do not fit.
Running multiple segments means a cable per channel. A 90/straight covers a channel from the head out to a ring - straight end in the head, 90 on the ring. Add a straight/straight to run two segments against each other, or to feed a Switch 1, whose input has to be straight. 2.5mm ends if you are on a Coyote, 3.5mm for most other boxes.
Details
Three M2×40 screw holes - one per port; each installed screw cuts that connection's resistance about 30% and strengthens the neck. Locks into its shaft with a 90° PlaLok™ turn - check the lock indicator before use.
Care: consumable part - inspect before every use, disassemble to clean with warm water and dish soap, and follow the Care and Safety Instructions.
Goes well with
The Pinnacle - Frenulum/Corona Tip Ring
The One - Round Shaft Ring
The Clarifier - Bipolar Shaft Ring
Switch 1
Really Good E-Stim Cable
Build your own 4mm cables
