Name: Eyes Head — 2 Conductor (MH-EYES2)
SKU: M25H-EYES2
Availability: OutOfStock

Description

Read the Full Story & Testing Notes Product Discussion on Discord (members)

The Eyes 2

Part number: MH-EYES2 (M25H-EYES2) · Conductors: 2, independently drivable · Available in: 25 Series · Print: ~3 hours (reflected in price)

All the standard head features, including 2 m2 screw holes in a double conductor head.

25 Series only. Heads are series-locked: you get the head built for that shaft diameter, and it fits that series only. A 25 Series head will not go on a 32 Series shaft.

Two independent zones

Two separate conductive eyes, each on its own 4mm port. Drive them separately or together.

Some ways to run it

There are a lot of ways to wire two zones. A few favorites:

A channel just across the eyes hits the prostate. Simple, and it needs no ring - but the current stays up in the head, running beside the prostate rather than through it.

The way I like best is one eye out to a ring. Take a tip ring like the Pinnacle and wire one eye to each side of it - corona side and frenulum side. That puts two channels down your shaft hitting both the perineal and dorsal nerves, converging on the prostate. Eye to eye is nice, but eye to ring is better.

Or one eye to a ring, the other to the peri pad on your probe. Heavy prostate, and a lot of movement from the pad.

With a Switch 1, put the ring on one pole of the channel and the other pole into the switch's 4mm input. A regular e-stim cable in the switch's 3.5mm jack goes to both eyes — flip between one eye, the other, or both mid-session. The A+B centre position changes the surface area of the head, which drives deeper prostate sensation and more intensity in the ring.

Cables - read this before you order

Clearance in the head is tight: the cable head has to be 8mm or under. If you already have 4mm cables, measure them first. Nothing is worse than a new head and the wires do not fit.

Two channels means two cables. A 90/straight covers a channel from the head out to a ring - straight end in the head, 90 on the ring. Add a straight/straight if you want to run the two eyes against each other. A Switch 1's 4mm input also needs a straight banana. The switch's 3.5mm jack takes a regular e-stim cable; those two 4mm ends are the two eyes, and both need to be straight if they land in the head. 2.5mm ends if you are on a Coyote, 3.5mm for most other boxes.

Details

Two M2×40 screw holes - one per port; each installed screw cuts that connection's resistance about 30% and strengthens the neck. Locks into its shaft with a 90° PlaLok™ turn - check the lock indicator before use.

Care: consumable part - inspect before every use, disassemble to clean with warm water and dish soap, and follow the Care and Safety Instructions.