Name: Bullseye Head — 2 Conductor (MH-BULL2)
SKU: M25H-BULL2
Availability: OutOfStock

Description

Read the Full Story & Testing Notes Product Discussion on Discord (members)

The Bullseye

Part number: MH-BULL2 (M25H-BULL2) · Conductors: 2, independently drivable · Available in: 25 Series · Print: ~3 hours (reflected in price)

All the standard head features, including 2 m2 screw holes in a double conductor head.

25 Series only. Heads are series-locked: you get the head built for that shaft diameter, and it fits that series only. A 25 Series head will not go on a 32 Series shaft.

Two independent zones

The Bullseye has two 4mm ports on the head - one for the inner section, one for the outer ring. They are independent, so you can drive them separately or together.

Some ways to run it

There are probably fifty ways to wire this head. Here are a few favorites to get you started.

1. Inner to outer, one channel. ChA into the inner Bullseye, other side of ChA to the outer ring. That is an intense prostate edge stim and it can be sharp. It is good - but there are a couple I enjoy more.

2. With a tip ring - one of my favorites. Using the Pinnacle: ChA from the outer Bullseye to the corona side of the Pinnacle, and ChB from the inner Bullseye to the frenulum (front) side. That puts two channels down your shaft hitting both the perineal and dorsal nerves hard, and converging on the prostate. Incredible feeling.

3. With any ring, plus the peri pad. Works with the Pinnacle, or a mono ring like The One, or the Clarifier. ChA from the ring to one Bullseye port, ChB from the other Bullseye port to the peri pad on your probe. Both heavy prostate, and a lot of movement from the pad.

4. With a Switch 1. Put a shaft or tip ring on one pole of the channel and the other pole into the switch's 4mm input. A regular e-stim cable in the switch's 3.5mm jack goes to both Bullseye ports. Now you can switch between inner, outer, or both. Start in A or B - whichever feels best - and when you are close, flip to the A+B centre position. That changes the surface area of the head, which drives deeper prostate sensation and more intensity in the ring.

So many options.

Cables - read this before you order

Clearance in the head is tight: the cable head has to be 8mm or under to fit. If you already have 4mm cables, measure them first. Nothing is worse than a new head and the wires do not fit.

Most of the setups above run two channels, so you will want two cables. A 90/straight covers a channel that runs from the head out to a ring - straight end in the head, 90 on the ring. Add a straight/straight if both ends land in the head. A Switch 1's 4mm input needs a straight banana. The switch's 3.5mm jack takes a regular e-stim cable; those two 4mm ends are the two Bullseye ports, and both need to be straight.

Not sure which end you need? 2.5mm if you are on a Coyote, 3.5mm for most other boxes. Ask and we will make sure you get the right ends.

Care: consumable part - inspect before every use, disassemble to clean with warm water and dish soap, and follow the Care and Safety Instructions.